Installation

1. Attach a “Capacitor Block” to each spark plug ignition wire with arrows pointing toward the spark plug. For ease of installation, make sure that the device is warm (Over 100 degrees F). A hair dryer, hot water, the car defroster or a low oven (100-125F) are possible choices. Each block will be flexible and clip on the wires more easily. 8 and 10 cylinder-see additional instructions in box.
2. The order of installation is not important. Just be sure to finish with at least 1 block on each plug wire.
3. After installation, wrap each block with a nylon zip tie provided with your Ionizer.
4. Start motor. Let idle for a few minutes. Turn off engine, retighten zip ties. Detach one battery cable.
5. Wait 1 minute. Reattach terminal. This resets the computer.
6. Final check:
• All arrows pointing toward spark plugs
• No blocks, connecting wires, or spark plug wires touching metal. This is critical. If this is a problem, use wire loom (available for purchase here on our website) to prevent anything touching metal.
• No plug wires touching each other.


Tech Support 800-967-0452